Poor Radio Reception

In Car Entertainment, Sat-Nav, Mobile Phones, Media players etc., whats hot, and whats not!

Moderator: Moderators

Post Reply
roton600
1.8 8v
Posts: 25
Joined: Thu Nov 19, 2009 8:54 pm

Poor Radio Reception

Post by roton600 »

Hi,

need some help i have an x reg 406 estate and have had for about 6 months now. The radio reception has always not been very good. Does it need the aerial replacing? Or the coax too?
User avatar
mjb
Site Admin
Posts: 7983
Joined: Wed May 31, 2006 9:06 pm
Location: Stoke

Re: Poor Radio Reception

Post by mjb »

FM? Is your aerial near the windscreen or tailgate?
<steve_earwig> I think this forum is more about keeping our cars going with minimal outlay than giving our cars more reason to go bang
roton600
1.8 8v
Posts: 25
Joined: Thu Nov 19, 2009 8:54 pm

Re: Poor Radio Reception

Post by roton600 »

Hi,

The aerial is at the front near the windscreen.
teamster1975
Site Admin & Mad Biker!
Posts: 6277
Joined: Sun Oct 28, 2007 8:07 pm
Location: Woking, Surrey

Re: Poor Radio Reception

Post by teamster1975 »

If memory serves (from previous posts on here) there is an circuitry built into the body of the aerial and this gets corroded. You should be fine just replacing the aerial. The AM antenna is built into the radio itself.
1996 406 1.8LX Got a bad case of hydro lock!
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there :(
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X

"Always look on the bright side of life, dedo, dedo dedodedo"
roton600
1.8 8v
Posts: 25
Joined: Thu Nov 19, 2009 8:54 pm

Re: Poor Radio Reception

Post by roton600 »

Thanks for the fast reply, off to mr peugeot tomorrow
User avatar
mjb
Site Admin
Posts: 7983
Joined: Wed May 31, 2006 9:06 pm
Location: Stoke

Re: Poor Radio Reception

Post by mjb »

Chances are the aerial connection's corroded. Here's briefly how to get at it (the guide may need modification if you've got a sunroof):

Use a flathead screwdriver to lever out the courtesy light - it's held in by a clip on the opposite side to the switch.
Unplug it.
Use a torx screwdriver to remove the 2 screws holding the panel in.
Remove the panel, I think it comes out windscreen side first. Unplug the light and temperature sensor.
You should see the aerial mount.
Use pliers or something to take the metal cover off, then unbolt the aerial. Alternatively you can unscrew it from on the roof, but it may well scratch the paintwork

Give it all a good clean with a wire brush and some electrical contact cleaner if you've got some
<steve_earwig> I think this forum is more about keeping our cars going with minimal outlay than giving our cars more reason to go bang
User avatar
mjb
Site Admin
Posts: 7983
Joined: Wed May 31, 2006 9:06 pm
Location: Stoke

Re: Poor Radio Reception

Post by mjb »

teamster1975 wrote:If memory serves (from previous posts on here) there is an circuitry built into the body of the aerial and this gets corroded.
I was under the impression the amplified aerials only came along when they got moved to the rear on estates. I could be wrong though....
<steve_earwig> I think this forum is more about keeping our cars going with minimal outlay than giving our cars more reason to go bang
teamster1975
Site Admin & Mad Biker!
Posts: 6277
Joined: Sun Oct 28, 2007 8:07 pm
Location: Woking, Surrey

Re: Poor Radio Reception

Post by teamster1975 »

mjb wrote:
teamster1975 wrote:If memory serves (from previous posts on here) there is an circuitry built into the body of the aerial and this gets corroded.
I was under the impression the amplified aerials only came along when they got moved to the rear on estates. I could be wrong though....
I can't remember to be honest, it was a while back! :oops:
1996 406 1.8LX Got a bad case of hydro lock!
1996 406 Executive 2.0 Turbo XU10J2TE No longer hangin' on in there :(
1997 Honda CB500V
2003 Volvo V40 1.8 GDi SE killed by a nutter in a beemer 5 series
2008 Mondeo 2.0 TDCi Titanium X

"Always look on the bright side of life, dedo, dedo dedodedo"
User avatar
Captain Jack
3.0 24v
Posts: 3820
Joined: Sun Aug 07, 2005 11:26 am
Location: Langford, Somerset

Re: Poor Radio Reception

Post by Captain Jack »

This is something I need to do myself. My radio reception is absolutely cr*p. When I had a Hyundai i10 while my '6 was being serviced (surprisingly nice car), the radio reception was miles better than in my Pug.

The HU is an Alpine, which has a power wire from the back for amplified aerials. This is something that I've been looking to do - but... can anyone recommend a nice amplified aerial? And will it be better than the standard one?
2003 - 2008: 1998 Peugeot 406 2.1 TD 110bhp LX Saloon
2008 - 2009: 2004 Honda Accord 2.2 CDTI 136bhp Executive Saloon
2009 - 2013: 2002 Peugeot 406 2.0 HDI 110bhp Executive Saloon
2013 - 2021: 2007 Peugeot 407 2.2 HDI 170bhp Executive Saloon (mapped to 213bhp :twisted:)
2021 - ????: 2016 Ford Mondeo 2.0 TDCi 180bhp Titanium
roton600
1.8 8v
Posts: 25
Joined: Thu Nov 19, 2009 8:54 pm

Re: Poor Radio Reception

Post by roton600 »

Thanks again guys

thats saturday lunchtimes job to do, take apart and have a look and see what i can do
User avatar
mjb
Site Admin
Posts: 7983
Joined: Wed May 31, 2006 9:06 pm
Location: Stoke

Re: Poor Radio Reception

Post by mjb »

Another point for corrosion to hit is between the whip and the base. Unfortunately it can cause the whip (which should just unscrew) to snap its screw thread in the base.
<steve_earwig> I think this forum is more about keeping our cars going with minimal outlay than giving our cars more reason to go bang
Post Reply