'STOP - Temp to high' and 'Fuel/Temp Gauge'?

Discuss, ask, or get help with engine and mechanical queries in here.

Moderator: Moderators

Post Reply
goldiejay
Newbie
Posts: 5
Joined: Tue Jul 17, 2007 12:51 pm
Location: Newport (The welsh one!)

'STOP - Temp to high' and 'Fuel/Temp Gauge'?

Post by goldiejay »

First time posting, so hoping some of you can help.
I’ve recently acquired a V reg. 406 2.0i (96000miles).
Car seems to run well (although I’m no expert suspect it may be mis-firing as seems to cough a splutter a bit when idling).
I have driven the car approx. 90 miles on the motorway with no problems at all, however I then hit some traffic and after 3-4 mins crawling along I got the ‘STOP- Engine temp to high’. This would warn for approx. 30 secs then all go quiet, would start up again about 4 mins later. Temp gauge through-out never went above 90oC (kind off assuming temp. works as seems to do whats expected from cold start)
What also happened at similar time was ‘fuel gauge’ and ‘temp gauge’ started to ‘bounce’ (they would drop-out briefly and then return to there actual readings), not sure if this has any bearing or relation but seems odd it all started at a similar time.

Any ideas or suggestions on this would be greatly appreciated, I don`t really want to turn up to a garage with out being slightly prepared. ( and this may be a common issue that some of you chaps may know off)

Cheers again
Eagles may soar, but ferrets don`t get sucked into jet engines!
User avatar
mjb
Site Admin
Posts: 7983
Joined: Wed May 31, 2006 9:06 pm
Location: Stoke

Post by mjb »

Welcome to the forum! It sounds like you're "just" suffering from electrical gremilins. I'm not familiar with the D9's setup (the later model of 406 which you have) but unfortunately problems like this aren't rare with them.

Someone else should be along shortly who is familiar with this stuff... I'd recommend finding out what's wrong with the help of the guys here then going to an independent garage to get it fixed if it's something you can't do yourself - Peugeot dealers aren't cheap, and some of our gurus here are much more knowledgeable!

Your idle problems may be caused by a duff idle control valve or throttle position sensor which I believe to be fairly cheap and easy to replace
<steve_earwig> I think this forum is more about keeping our cars going with minimal outlay than giving our cars more reason to go bang
goldiejay
Newbie
Posts: 5
Joined: Tue Jul 17, 2007 12:51 pm
Location: Newport (The welsh one!)

Post by goldiejay »

Cheers for the reply, and thanks for the welcome...

Well here's hoping it is some electrical gremlins.... I await with baited breath the views of some the other guys :idea:
Eagles may soar, but ferrets don`t get sucked into jet engines!
User avatar
Welly
The moderator formally known as Welton
Posts: 15033
Joined: Tue Jan 10, 2006 12:52 pm
Location: East Midlandfordshire

Post by Welly »

Welcome, it is an electrical fault to do with the resisters/relays which work the radiator fan.

Have a look here, it should help (courtesy of Foggy on here) viewtopic.php?t=1452&start=0&postdays=0 ... highlight=

Welly

Please ignore my Sig picture, it's a bet, and I'm a nice normal guy really.
Cars in my care:
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
goldiejay
Newbie
Posts: 5
Joined: Tue Jul 17, 2007 12:51 pm
Location: Newport (The welsh one!)

Post by goldiejay »

Cheers,
Seen that post/guide while trawling this forum before I posted. :cheesy:

Wanted to see if you guys with extra knowledge could eliviate my fears, and come with anything else that may be a issue.

Good 'ole foggy, great guide, and I will be trying that as my earliest opportunity.

I`ll let you know if it resolves the issue, and if not....... i shall return with more questions :lol:

Cheers for the swift replies.....
Eagles may soar, but ferrets don`t get sucked into jet engines!
User avatar
Welly
The moderator formally known as Welton
Posts: 15033
Joined: Tue Jan 10, 2006 12:52 pm
Location: East Midlandfordshire

Post by Welly »

My car failed the other way round, the Fan itself crapped out :cry:

£280.00 later it was fixed (after mucho investigation due to Engine Check Light on).
Cars in my care:
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
User avatar
puggy
Resident Pervert
Posts: 3251
Joined: Tue May 01, 2007 7:47 am
Location: staffordshire

Post by puggy »

Welton wrote:Welcome, it is an electrical fault to do with the resisters/relays which work the radiator fan.

Have a look here, it should help (courtesy of Foggy on here) viewtopic.php?t=1452&start=0&postdays=0 ... highlight=

Welly

Please ignore my Sig picture, it's a bet, and I'm a nice normal guy really.

no its not a bet welly is in fact a post whore a very nice one but never the less he is, as regards
the other well, have heard in the closet and coming out mentioned but i try not to get involved in the
tacky side of the forum :shock:

Welcome by the way :D :D
.. ooh are those drugs for me Matron
goldiejay
Newbie
Posts: 5
Joined: Tue Jul 17, 2007 12:51 pm
Location: Newport (The welsh one!)

Post by goldiejay »

I`d have to say 'no comment'.... being new here and all that..

But, I have noticed lots of posts by welly through-out the forum.... so he`s either a very nice bloke, or as his sig suggests a 'post whore' :cheesy:


Either way..... 'tis all good.. :D
Eagles may soar, but ferrets don`t get sucked into jet engines!
User avatar
DaiRees
Site Admin
Posts: 5377
Joined: Sat Aug 06, 2005 8:24 am
Location: Merthyr Tydfil, South Wales (God's Country!)

Post by DaiRees »

He's certainly a post whore :!:

As far the question of his gayness goes, I personally think he's just very very happy :wink:


Welcome by the way 8) :cheesy:
Image
Playtime_Fontayne wrote:"Dai Rees Supplier of Fine Automobilia. Established 2007"
User avatar
Welly
The moderator formally known as Welton
Posts: 15033
Joined: Tue Jan 10, 2006 12:52 pm
Location: East Midlandfordshire

Post by Welly »

I'll have you know I'm a [s]happily[/s] married man, and a proper blokes bloke, and built like a horse, or was it hung like a horse....oh wait.
Cars in my care:
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
goldiejay
Newbie
Posts: 5
Joined: Tue Jul 17, 2007 12:51 pm
Location: Newport (The welsh one!)

Post by goldiejay »

And now its all getting a little intriguing... or was that concerning?
Eagles may soar, but ferrets don`t get sucked into jet engines!
User avatar
Welly
The moderator formally known as Welton
Posts: 15033
Joined: Tue Jan 10, 2006 12:52 pm
Location: East Midlandfordshire

Post by Welly »

Arrrgh Bejesus, not another Welsh member :cry:

Was is it with you lot and 406's????

There are so many of you on here you will need your own sub-section soon :roll:
Cars in my care:
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
Post Reply