the v6 coupe replacement
Moderator: Moderators
the v6 coupe replacement
Well after 15 years of Peugeot ownership
309 gti goodwood
306s16
406v6 coupe
It was time to move on and try something new, as my car isn't the main car and I only do circa 2k a year fuel bills etc arnt a problem.
The search list was small but was a mix of German and jap rear wheel drive cars.
The car in question is
Rear wheel drive
4 door
Six speed
Normaly aspirated
231 bhp
Has a few things to sort like the wheels but on the hole it's a good car
That 9000rpm rev limit is amazing as is the noise it makes whilst getting there
309 gti goodwood
306s16
406v6 coupe
It was time to move on and try something new, as my car isn't the main car and I only do circa 2k a year fuel bills etc arnt a problem.
The search list was small but was a mix of German and jap rear wheel drive cars.
The car in question is
Rear wheel drive
4 door
Six speed
Normaly aspirated
231 bhp
Has a few things to sort like the wheels but on the hole it's a good car
That 9000rpm rev limit is amazing as is the noise it makes whilst getting there
- highlander
- PowerFlow Shill
- Posts: 3548
- Joined: Sun Nov 09, 2008 5:03 pm
- Location: Aberdeen
Re: the v6 coupe replacement
Very nice RX-8! I've always been quite keen on the styling of those.
Aren't the engines on those quite keen on lunching themselves? Oil starvation issues, etc?
I've read many a post on Pistonheads where someone's re-engined one whose engine has already bit the dust, and quite a few people have said the Wankel engine it uses doesn't have a particularly long service life. Shame, cos the rotary engine idea seems to be really clever to me.
It's stuff like that that's put me off having one of them, rather than anything else. The rear "suicide" doors are a really good idea and work well.
Aren't the engines on those quite keen on lunching themselves? Oil starvation issues, etc?
I've read many a post on Pistonheads where someone's re-engined one whose engine has already bit the dust, and quite a few people have said the Wankel engine it uses doesn't have a particularly long service life. Shame, cos the rotary engine idea seems to be really clever to me.
It's stuff like that that's put me off having one of them, rather than anything else. The rear "suicide" doors are a really good idea and work well.
2002 (D9) Peugeot 406 Coupe SE, 2.2 litre Petrol. Scarlet Red/Rouge Ecarlate/Rosso Scarlatto. Black Leather interior. SOLD
2008 (E60 LCI) BMW 525i M-Sport, 3.0 litre Petrol. Carbonschwarz Metallic. Black Dakota Leather and Myrtlewood interior.
2008 (E60 LCI) BMW 525i M-Sport, 3.0 litre Petrol. Carbonschwarz Metallic. Black Dakota Leather and Myrtlewood interior.
Re: the v6 coupe replacement
Have a very good look at the handbrake, if you thought the 406 handbrake has a bad reputation, these are much worse....I've seen a few of these roll away downhill, including one owned by a customer which she just bought, parked it on her steep drive and lost it down the drive into a wall at the other side of the road!
Keep a regular check on the oil!!
Nice looking car, enjoy
Keep a regular check on the oil!!
Nice looking car, enjoy
Re: the v6 coupe replacement
Yes they engines use oil but no more than some other cars and if liked after can do well in to the 100k catagory
They do need regular maintance though!!
For the money they are exceptional value
They do need regular maintance though!!
For the money they are exceptional value
Re: the v6 coupe replacement
Nice car, atrocious parking
<steve_earwig> I think this forum is more about keeping our cars going with minimal outlay than giving our cars more reason to go bang
- Welly
- The moderator formally known as Welton
- Posts: 15033
- Joined: Tue Jan 10, 2006 12:52 pm
- Location: East Midlandfordshire
Re: the v6 coupe replacement
At last! someone with worse MPG than my T5
Those RX's are mega cheap because everyone is scared of them, make a bargain if you get a good 'un.
Something I learnt watching Wheeler Dealers last week was that the rotor tips wear due to the centrifugal forces against the 'cylinder' walls, increasing the revs increases the wear they kinda wear themselves out. I think you can look after engines like that by being sympathetic and using super-quality oil.
Those RX's are mega cheap because everyone is scared of them, make a bargain if you get a good 'un.
Something I learnt watching Wheeler Dealers last week was that the rotor tips wear due to the centrifugal forces against the 'cylinder' walls, increasing the revs increases the wear they kinda wear themselves out. I think you can look after engines like that by being sympathetic and using super-quality oil.
Cars in my care:
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
2021 Kia Spottage 1.6 Pez Turbo Dual Clutch Gearbox Trickery
2013 Renner Twingo - donkey work
Re: the v6 coupe replacement
I didn't park it like that, the guy I purchased it from did whilst I got him so e cash from the bank.
It's very common amongst club members to add some fully synthetic 2 stroke oil to your petrol, this burns clean but also aids lubrication of the rotor tips at the same time .
Also a lot of people run 10w40 rather than 10w30 which is the recommended oil
Plenty of people on the forums with high Milage cars that haven't has a rebuild!
Once I get the drive back properly it will be getting a good service and the mods can start getting done
It's very common amongst club members to add some fully synthetic 2 stroke oil to your petrol, this burns clean but also aids lubrication of the rotor tips at the same time .
Also a lot of people run 10w40 rather than 10w30 which is the recommended oil
Plenty of people on the forums with high Milage cars that haven't has a rebuild!
Once I get the drive back properly it will be getting a good service and the mods can start getting done
-
- 3.0 24v
- Posts: 552
- Joined: Sat Aug 25, 2012 9:15 pm
- Location: Axbridge, Somerset
Re: the v6 coupe replacement
This is what did for NSU, the maker of the original rotary, the NSU Ro 80. The rotor tips were failing at low mileages, and NSU faithfully replaced the engines under warranty.., until they were effectively bust. ( VW took them over, and they became what is now Audi )Welly wrote:At last! someone with worse MPG than my T5
Something I learnt watching Wheeler Dealers last week was that the rotor tips wear due to the centrifugal forces against the 'cylinder' walls,
Surprised to read that this is still a problem.
- Attachments
-
- images.jpg
- (8.21 KiB) Downloaded 237 times
2006 Toyota Yaris 1.0 T3
1993 Mazda MX5 Mk1 1.6
2000 "W" HDI 110 Executive Saloon (Recycled).
1993 Mazda MX5 Mk1 1.6
2000 "W" HDI 110 Executive Saloon (Recycled).
Re: the v6 coupe replacement
Mazda did address the tip failurs, many rx8 on well over 75000 miles without a rebuild.
It's common practice these days to run a small amount of fully synthetic two stroke in the petrol to help keep things lubricated.
Any way have finally had chance to clean it , clay bar, two coats of autoglym Srp, coat of poor boys black hole, and shortly it will get a cost of nattys blue wax
Have a rotary v badge to fit on the front
but it needs a bit of work so is presently sat in primer.
Then it will be on the wheels which are getting painted PEUGEOT graphite grey (have to get a bit of French on it)
And here is the coupe being taken away, think I got all the good bits off it !!
It's common practice these days to run a small amount of fully synthetic two stroke in the petrol to help keep things lubricated.
Any way have finally had chance to clean it , clay bar, two coats of autoglym Srp, coat of poor boys black hole, and shortly it will get a cost of nattys blue wax
Have a rotary v badge to fit on the front
but it needs a bit of work so is presently sat in primer.
Then it will be on the wheels which are getting painted PEUGEOT graphite grey (have to get a bit of French on it)
And here is the coupe being taken away, think I got all the good bits off it !!
-
- 2.0 HDI 110
- Posts: 9656
- Joined: Tue Jun 01, 2010 5:42 pm
- Location: The Countryside, Northern Ireland
- Contact:
Re: the v6 coupe replacement
Just out of interest how much is a tax disk for a V6 coupe?
Re: the v6 coupe replacement
£280 a year unless it's gone up again
Re: the v6 coupe replacement
Depends when it was first registered. eg a V6 registered before 1/4/01 will be £230 per year.
http://carfueldata.dft.gov.uk/new-vehic ... ?t=23ude39
http://carfueldata.dft.gov.uk/new-vehic ... ?t=23ude39
2001 ES9J4S Coupe Manual Diablo
Re: the v6 coupe replacement
Welcome to the Mazda club!
Are Mazdas the new "Volvo".....?
Are Mazdas the new "Volvo".....?
Re: the v6 coupe replacement
Don't think the service record is accurate!
Last time I looked the airfilter shouldn't be this colour!
Yep that's the spark plugs, you access them via the passenger side front wheel arch!!
Other two are too the left as you look at that image !!
Also discovered that it needs a new passenger side droplink
Last time I looked the airfilter shouldn't be this colour!
Yep that's the spark plugs, you access them via the passenger side front wheel arch!!
Other two are too the left as you look at that image !!
Also discovered that it needs a new passenger side droplink
-
- 1.8 8v
- Posts: 38
- Joined: Thu Apr 24, 2014 4:02 pm
- Location: Bradford - unfortunatly
Re: the v6 coupe replacement
I worked for mazda for around 3 years while the rx8 was new.
Pretty good cars.
1ltr of oil every 1000mile is what mazda say. Common faults are intercooler oil pipes corroding.
Drop links snap for fun.
and the most common is people flooding the engine and then the car wont start again. Thi is causef by people not turning off the engine correctly.
sounds daft but there is a set procedure for stoppingvthe engine. I have got somewhere a little book direct from mazfa on how this all works if its anygood to you??
Pretty good cars.
1ltr of oil every 1000mile is what mazda say. Common faults are intercooler oil pipes corroding.
Drop links snap for fun.
and the most common is people flooding the engine and then the car wont start again. Thi is causef by people not turning off the engine correctly.
sounds daft but there is a set procedure for stoppingvthe engine. I have got somewhere a little book direct from mazfa on how this all works if its anygood to you??
LOW AND SLOW ALL THE WAY