How do you remove the backseat? (to run amp cables)
Moderator: Moderators
How do you remove the backseat? (to run amp cables)
ive managed to get to the grommit on the "how to guide" that i saw on here, but im trying to find the rest of the route to the boot, does everyone go along the sill and under the seat? if so ive been trying to get the backseat up or off so i can run the cables, they say you pull and push back but i still cant get it out
- HimBigChief
- 3.0 24v
- Posts: 1104
- Joined: Tue Dec 09, 2008 5:05 pm
- Location: Rural Northumberland
- Contact:
Re: How do you remove the backseat? (to run amp cables)
Can't remember exactly, but I removed all the interior side trims and ran the wire up there, then lifter the corner of the seat and ran it through to the boot from there. IIRC it was a little fiddly but easily done in the end. I'll probably redo it with heavier gauge wire when I up the system in the boot.
Re: How do you remove the backseat? (to run amp cables)
At the front of the seat either side should be 2 rubber bungs, pull them off, and there is - think it;s 2 nuts, but being a pug probably 2 torx - undo and the seat base will pull out. Only takes couple of mins.
1999 D8.5 HDi GLX - Sold
2007 Mondingo Zetec - I seek forgiveness Bring back my 406
2007 Mondingo Zetec - I seek forgiveness Bring back my 406
Re: How do you remove the backseat? (to run amp cables)
ive got the 2 screws off but the seat is still secured onto something, it lifts up from the front but the back is stuck down, this is what i cant do
Re: How do you remove the backseat? (to run amp cables)
I found the Haynes manual to be bang on for the job...
<steve_earwig> I think this forum is more about keeping our cars going with minimal outlay than giving our cars more reason to go bang
Re: How do you remove the backseat? (to run amp cables)
I have found out (after a lot of tugging, pulling. lifting and swearing) that there are 2 'mushrooms', 1 on the body floor under each seat, that locate into a ring on the bottom of the seat. You just need to get the right combination of tug, pull, hit and twist to get it off!
Just try lifting the front of the seat up away from the bolts and then give it a whack towards the back of the car, that should dislodge the seat from the mushroom.
Just try lifting the front of the seat up away from the bolts and then give it a whack towards the back of the car, that should dislodge the seat from the mushroom.
D8 2.0 16v LX 406 Saloon
Re: How do you remove the backseat? (to run amp cables)
This was very helpful to clean up a spill. Thanks
Re: How do you remove the backseat? (to run amp cables)
I used to have spills on the back seat...........Happy Days........
2001 ES9J4S Coupe Manual Diablo
- Captain Jack
- 3.0 24v
- Posts: 3820
- Joined: Sun Aug 07, 2005 11:26 am
- Location: Langford, Somerset
Re: How do you remove the backseat? (to run amp cables)
Thanks for that, markw....
2003 - 2008: 1998 Peugeot 406 2.1 TD 110bhp LX Saloon
2008 - 2009: 2004 Honda Accord 2.2 CDTI 136bhp Executive Saloon
2009 - 2013: 2002 Peugeot 406 2.0 HDI 110bhp Executive Saloon
2013 - 2021: 2007 Peugeot 407 2.2 HDI 170bhp Executive Saloon (mapped to 213bhp )
2021 - ????: 2016 Ford Mondeo 2.0 TDCi 180bhp Titanium
2008 - 2009: 2004 Honda Accord 2.2 CDTI 136bhp Executive Saloon
2009 - 2013: 2002 Peugeot 406 2.0 HDI 110bhp Executive Saloon
2013 - 2021: 2007 Peugeot 407 2.2 HDI 170bhp Executive Saloon (mapped to 213bhp )
2021 - ????: 2016 Ford Mondeo 2.0 TDCi 180bhp Titanium