406oc.co.uk

Back again.....

Just a quick check before I order - on driverside I have just noticed that a rubber mount, near driveshaft, bolts on to the lower rear of the block and has a rubber centre, has split - is this the rear mount? looks like this ( http://cgi.ebay.co.uk/PEUGEOT-206-1-4-1 ... 9129408753 ) but on a V reg 406 2.0 HDi

Any info greatly appreciated - if you have a Haynes for the 2.0HDi 1999 - 2002 it is on page 10.8, picture 10.3 and the bit I'm on about is the rubber where bolt A is highlighted

Cheers
Gaz

jasper told me yesterday or the day before to change the bottom mount you have to remove drivers side drive shaft and take the whol mount off then get a garage to change the bush

that was for my 1,9 td .. it will probably be a similar procedure for the HDi ...

Ahhaa - it's the rubber that the movement limiyer bolt goes through

It looks like I could get to it with the car on ramps, new mount in freezer and heating up housing once I cut out the old one with my Dremmel - any views on this - also, is it the rear mount I need to order or steel elastomer or are these the same thing? Its where the bolt for the movement limiter goes through, it joins to the horizontal Y shaped jobby and under/near the driveshaft

Cheers troops
Gaz

member
adam486749939202048842 did his on the car and he said he would never do it again
its a real pain , hard job

but if you feel upto it good luck with it maste let me know how u get on as i want to do mine