406oc.co.uk

Hi All
Having issues with the random 'Anti Pollution Fault' warning and EML on.
I cannot get the codes read as the is no power to the OBD (getting it looked at next week)

I have had a full service since the problem occured including:
Engine Oil and Filter
Air Filter
New Plugs (£52 Ouch!)
Fuel Filter

BUT... I now have a misfire usually about 2,000-2,500 rpm on a light throttle, (more like cutting out or a hesitation or fuel cut off) AND its started stalling occasionally which it has never done before?
Misfire goes when you apply full throttle.

Also, if I rev the engine to 4,000 hold it for a few seconds then release, the 'AntiPollution Warning' pings again, it doesn't do it below 4,000 though?

The car has had replaced prior to me owning it:
Valve Solenoid
High pressure Fuel Pump
Oxygen Sensor
Various Engine Bay Sensores and wiring?
I think the EGR was relpaced also as it looks new, but have no record in the service records.

Any advice appreciated, but feel sure it must relate to the fuel/ingintion system in someway

GTXJez wrote: The car has had replaced prior to me owning it:
Valve Solenoid
High pressure Fuel Pump
Oxygen Sensor
Various Engine Bay Sensores and wiring?
I think the EGR was relpaced also as it looks new, but have no record in the service records.

Any advice appreciated, but feel sure it must relate to the fuel/ingintion system in someway

Bejesus! the last owner got taken to the cleaners there

You need to speak to DaiRees on here, he's had the same problem but I can't quite remember what it was in the end, try searching his posts, I've altered the thread title to provoke some attention too.

Daft question,
but as the car been using any water at all.?

this sounds simalar to something ihad recently,

lozz wrote:Daft question,
but as the car been using any water at all.?

this sounds simalar to something ihad recently,

No, not a drop..... temp Gauge stays at 90 all the time too

Welly wrote:

GTXJez wrote:
Bejesus! the last owner got taken to the cleaners there

You need to speak to DaiRees on here, he's had the same problem but I can't quite remember what it was in the end, try searching his posts, I've altered the thread title to provoke some attention too.

thank fully Welly! the expensive stuff got doen before I got it!!
Motor is in top notch condition, just these annoying issues, but it is still 100% reliable............ (Should be really!!)

I presume you've come across this viewtopic.php?f=1&t=3658&start=60&hilit=paste+coil