406oc.co.uk

Cheers - I'll head over to the FB group

Hello all

My MFD is now unreadable, so I am looking to 'downgrade' my satnav multi function display to the non sat nav version - i understand this is plug abd play and doesn't have the problems the sat nav version has.

Does anyone have one for sale?

Thanks
Richard

this sounds like a similar issue to a saga i experienced with my 406 - it would sometimes start and tick over then not start at all - in the end it turned out to be the BSI (body control unit) mine my changed with one from a breakers and has been fine ever since

Good luck

Hello everyone Having a bit of a nightmare with a Dav Comm plunger replacement. Unfortunately when pulling out the indicator stalk I pulled a bit too hard and the wire from the headlight switch pulled out from the inside of the stalk. I couldn't see how to get inside the stalk so put everything back...

Hello all

This was is now solved ! it was the engine fuse board (BSM)

thanks for all your help and suggestions

now its back on the road I'm thinking about changing seats and door cards for black leather - anyone got one in Cornwall?

Thanks Steve

I have looked in the footwell and all the wiring and connectors is clean and dry. I might try the relay/fuse board

update on this one... I have now tested the following components: hi lift fuel pump in tank - replaced with secondhand and fault remained - also tested by diesel specialist crank sensor diesel pump - tested by diesel specialist engine ecu - sent away for testing by ECU specialist and also tried usin...

Hi, have checked cam/crank synchronisation on PP2K - it says NO .....is this because its not running or a reason why its not starting??

ok, I'll have another look tonight after work. ECU is unlocked - checked late last night

Have you got a reasonable cranking speed? - ecu needs to 'see' 60RPM before it will trigger the injectors. Yes, new battery and starter replaced recently with one from breakers When you look at 'ecu condition' via PP2k, does it say 'unlocked'? Will check this one in an hour or so - just charging my...

Hi, yes the lift pump runs when I turn on the ignition.

OK have tried crank sensor (from breakers ) and fuel filter that I took off at a previous service and was working at the time - still no luck. if anything its now worse as it was starting after i left it alone for day - now just turning over.

Any ideas?

i'll also price up a crank sensor

I am looking for some help with my 03 406 2.0hdi Is it a 90 or 110, Richard? Its a 110 Thanks for all the quick replies. I did change the fuel filter recently and just changed the inner filter rather than the whole housing, I have done this before without issue. I'll try a BSi reset first as its fr...

right here goes: BIS Faults 1. Intermittent fault, absence of communication with engine management ECU 2. Remote intermittent fault vehicle speed information. Incorrect value received 3. Remote intermittent fault vehicle longitudinal acceleration information, incorrect value recieved no 1 seems to b...