406oc.co.uk

any interest?

Dont think i could sell seperately mate as the wheels wouldnt go on a peugeot then... You can bid me on the wheels still if you want lol

Liking that coupe mate. The wheels suit her well!

Yeah the spacers are hubcentric. The wheels are in very good condition and I dont want to let them go because I hunted a long time to find a set that are 19's and as good condition as these were!

The car had 60mm lowering springs with 2 coils off at the back and just 60mm at the front mate. The wheels fit the peugeot stud pattern so it would be 4x108. The spacers are 20mm thick and there is longer wheel studs to accomodate this change. The spacers and studs are all included in the price. Whe...

For sale. Wheels are ford fitment. Spacers and wheel nuts included in sale to change to peugeot fitment and fit snug on a 406. Need tyres (1 good tyre with plenty of tread). In good condition . £200 http://i307.photobucket.com/albums/nn313/jimmartin1/385322_2393180002647_1645331311_2341670_114823914...

Cheers for the help lads, just thought it was a lil bit tight so didnt want to horse it out incase i put it in shite! a wee wigg got it out grand!

I am removing the dashboard clocks on my 1998 d8 406. So far i have took off the plastic panel which encases the 3 airvents (it is the one with 3 torx screws above the steering wheel). I have also removed the 4 torx screws (2 above and two below) from the display panel. The dashboard display is stil...

So im back at the 406's again... After this car ran out of test and that i never really bothered... Over the winter there got her out and ready... Still a good wee bit to come with this car C + C appreciated lads! http://i307.photobucket.com/albums/nn313/jimmartin1/HPIM1773.jpg http://i307.photobuck...

Felt spec FTW ... Lad i see you have them out there lol

Complete engine for breaking... injectors etc... Also rear lifter pump... anything required sure give me a shout!

Well fellas, i know this topic has probably been covered before but im looking sum advice which is specific to my problem because my knowledge of wiring is very, very basic :D . I have got a Lx diesel 406 and can get the leather interior out of a 97 executive... id have access to get controls if nee...

hmm well i think its actually going because when the ignition is turned on you can hear the pump switching on and fuel gushing through... Also i jacked the car up about 2 feet at the toe bar so it was sitting forward. I opened the little bleeder valve a little and switched on ignition. There was a w...

Week 2 without a car and the bus is really starting to wear thin :x Well i got the hdi hooked up to the computer to see what the fault was... The mechanic reckoned that it was the back fuel pump as said on here but i got the cak seat pulled out to see what was happening and pop she goes... the buzzi...

Cheers for the help lads but looks like ill be needing a new pump.... Nothing is working. :evil: :evil: haha Just an idea, but i have 2 D-turbo engines lying in the yard for 406's, both of which start first turn. Would there be much hassle in changing a HDi to a Dturbo. As far as i can see the HDi h...

Cheers for the help above, but still nothing happening... the car is just turning over but not starting @ busman... the low pressure pump is definately going and is buzzing like it should @406silverhdi... Tried hwat you said but no go... still just turning over Cheers for the help and any more ideas...