Search found 29 matches

by Dano41
Fri Mar 09, 2018 4:18 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

It was the plugs folks two dead out of 3, I have only managed to get 3 in so far.That one behind the pump is a bugger.The car starts immediately the heater light goes out.Any ideas of how to get that last plug out.I wish someone had a youtube video on how to do it.Thanks to you all for taking the ti...
by Dano41
Wed Mar 07, 2018 7:54 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

Ok folks thanks for sticking with me.Will replace plugs and report back.
by Dano41
Wed Mar 07, 2018 10:53 am
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

Tried by passing the relay there was 25 amps been drawn on the cable it would not start.Would you rule out the heater plugs completely now?Put a heat gun on the block for 10 mins and started first turn.Slightest bit of blue smoke for a few seconds then clear.
by Dano41
Tue Mar 06, 2018 3:24 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

No,I will try bypassing and see if any better.
by Dano41
Tue Mar 06, 2018 1:26 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

Peter the engine does tick over evenly.
by Dano41
Tue Mar 06, 2018 1:16 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

That is the way I tested them and all good.If the timing belt has slipped could this still be the reason for the hard starting when cold?Would the engine not be running differently because the belt has slipped?
by Dano41
Tue Mar 06, 2018 12:54 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

Its a 1.9 turbo diesel engine.There is blue smoke for about 15 seconds when it starts.Its the same as this one.Peter would you convinced it is not the heater plugs from the tests I've done?
by Dano41
Tue Mar 06, 2018 12:08 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Re: Hard to start

Thanks for replies.The engine dosen't over heat now so I presume the water pump is working ok.If the head gasket was gone would there the oil not be emulsified or bubbles in the coolant tank.I checked the heater plugs by the test light method and also a clamp ammeter which is showing 25 amps before ...
by Dano41
Sat Mar 03, 2018 4:09 pm
Forum: Engine, Clutch and Transmission
Topic: Hard to start
Replies: 18
Views: 11565

Hard to start

Hi,started my 406 TDI 1999 saloon the other morning and the temperature rose very quickly I discovered that the engine was partially frozen.I pulled in till temperature dropped again,there was steam coming from from the header tank.It is now very hard to start at least 3 or 4 tries with turning over...
by Dano41
Sat Apr 16, 2016 10:07 am
Forum: Electrical System and Diagnostics
Topic: Fuses identification
Replies: 8
Views: 5964

Re: Fuses identification

I read that the wire loom at the hinge side of the door gets damaged.
by Dano41
Fri Apr 15, 2016 3:59 pm
Forum: Electrical System and Diagnostics
Topic: Fuses identification
Replies: 8
Views: 5964

Re: Fuses identification

The locks all close and then all open immediately.
by Dano41
Thu Apr 14, 2016 8:35 pm
Forum: Electrical System and Diagnostics
Topic: Fuses identification
Replies: 8
Views: 5964

Re: Fuses identification

Thank you very much for taking the time to reply.That is the chart for my fuse board checked some of the fuses and they matched.For some reason the fuses that say they are connected to the central locking when removed don't turn it off.Do I get to the control box through the glove compartment or in ...
by Dano41
Thu Apr 14, 2016 5:43 pm
Forum: Electrical System and Diagnostics
Topic: Fuses identification
Replies: 8
Views: 5964

Fuses identification

Hi has anyone got the same fuse box as mine in the pic and can give me a chart that tells me what all the fuses are?Its a 1999 406 diesel saloon.Also can anybody tell were and how to get to the central locking control box?Pic is upside down sorry.
by Dano41
Sat Apr 09, 2016 1:50 pm
Forum: Electrical System and Diagnostics
Topic: Heater blower not working
Replies: 9
Views: 8130

Heater blower not working

Hi,I have a 406 diesel saloon 1999 the heater blower is not working.Read other threads on the net and on here a lot of them are out of date or the pictures are no longer accessible or seem to be different from mine.I have checked the blower with another battery connected to the red and black wires w...