406oc.co.uk

The car does not bounce, it isn't wobbling about... If I press the back side down it doesn't bounce up and down... Maybe some arm bushing or droplink... Main dealer only assumes it's a failed shock absorber... How can I check if arm bushing or drop link is a cause of noise?

Hi! I bought Yatour a week ago. Enabled CD changer in PP2000 at my main dealer's and I am very happy with result. I have CD quality sound, and 6 virtual CDs with max 99 tracks on each CD. Can only recommend!

Should I tackle DIY job of replacing rear shocks on my 2003 Hdi? I have the tools, I can spin the spanners, but how hard is it? Removal of boot trim isn't the problem, but must I lift the car on axle stands, or can it sit on the ground? I have a thumping noise rear / right . Main dealer said the sho...

139.178 miles converted from km... Going on strong...
Still plenty of life in that engine I hope...

It took me several hours of laying on the ground under the car because of that bolt... Finally it gave in... Did a lot of swearing too It helped

Like a damn fire truck with a siren on

Solved!

Upper bolt is a pig to remove... Will probably turn over and over and will struggle to be removed ...

steve_earwig wrote:

Pugi4o6 wrote:Screwdriver... and turn it...

Well of course, but no recommendations where to point it or which way to turn it.

Watch the beam as you turn it...

I guess it must be, I've never had to fiddle with any of mine, not even to replace a bulb (oh dear...) In fact, not on any car I've ever had, they're usually just "there". Nothing useful in the repair manual (there never is): Remove : The mountings (3) The fixing (4) (Torx-headed driver : N° 30) Th...

Da, ima šaraf sa zadnje strane... nije valjda tamo za bezveze
There is a bolt on the reverse side of the foglight...
Beneath the blue connector on the right

I would like to ask for instructions on how to adjust the foglights beams... Any advice?
I know where the lever adjuster is and how to turn it... I just don`t know how to high to adjust the beam...
P.s. Bolt on the upper holder is a pig to remove

Got the buffers today. I`ll insert it where it goes tomorrow:) Also bought a new set of Goodyears for the next summer...
Damn... i`m exaggerating

Hello.

Changed the plate today. Rusty as hell... Bearing is ok, and therefore was put back on.. Hub and bearing did not come aparr... He didn't even dissasemble the rear shoes, as they were reused also. Handbrake works

Thumbs up! Got it cheap! In general, part in UK are cheap. Those headrests would cost me a small fortune in mt country... Btw.. We want pics