406oc.co.uk

Hi all

Can anybody help at all?..... I need the Technical Data or a repair manual so that i can do an engine rebuild on my XU10J2TE unit. I have tried everywhere and even at my local Peugeot dealer i got a blank look off the service dept.

Any help is really appreciated

HI All I still have this erratic idle issue, the engine idles up and down between 950-1100 rpm, i have a brand new iacv fitted, the Throttle position sensor appears ok, disconnecting it makes no difference to the idle either. On a better note, the car is now finished and on the road, flew through th...

Ok it's been a while since I posted but I cured the fault, there was a feed wire that goes from the relay block to the iacv that was corroded.

Since then the engine will not idle properly, it hunts like mad. Lost on this one as it has a brand new iacv

Anybody got any clues to cure it?

Hi all, I have recently transplanted a xu10j2te from a citroen xantia into my Peugeot 306. All was fine apart from on starting, the engine revs jumped to 3k and stayed there. Unplugging the throttle position sensor dropped the revs down to 1500 rpm, I tried two other position sensors and the same oc...

I think the IACV is faulty but at £112 that one is going to have to wait. Another person on the 306 forum has said that the TPS and the IACV need calibrating????, Such a shame as the project was going so well. :cry: Another person said it could be an air leak?? If it is the ECU however i am looking ...

I have finally got my project running but from when I started it up the revs slowly went up to 4000 rpm and stayed there. I disconnected the throttle position sensor and the revs dropped to 1500 rpm. I changed the throttle pos sensor but did not cure the fault. The car has no exhaust on it so no lam...

If anybody has any pictures of the Nissan 200sx turbo fitted to the XU10J2TE and can post them here for me i would be most greatful.

My only concern is that if its much bigger than the standard turbo i am going to have clearence issues with my 306 as it is quite a tight fit already.

Greetings all. Currently i am building a 306 with the XU10J2TE Engine. My engine has come from a Citroen Xantia Activa, I know this engine is also used in the 406 SRI. Can anybody give me some tips on tuning please, the engine is currently running 15PSI of boost and is producing around 170bhp, i wan...