going to have a go at welding the sills !

Discuss the 406's Bodywork stuff in here (what parts fit what, what can be interchanged with what etc etc).

Moderator: Moderators

dirtydirtydiesel
3.0 24v
Posts: 1308
Joined: Sun Apr 28, 2013 11:02 pm
Location: Coalville, Leics.

Re: going to have a go at welding the sills !

Post by dirtydirtydiesel » Sun Jan 13, 2019 10:51 pm

PhillipM wrote:
Sun Jan 13, 2019 6:39 pm
Gas mig.
Gasless is a pain in the arse as it starts much worse than gasless and you'll have to do more cleanup, TIG is a waste of time unless you cut it back to completely perfectly clean metal and get your repair seamless - and you have it indoors otherwise the wind is a nightmare.
Stick welder? Forget it on car bodywork. It can be done, yes, but it always ends up a hell of a mess to sort out.
B
Beware that slapping a patch over the top usually just means the rest of it will rust even faster as you've created a moisture trap. So if you're keeping the car, worth doing it right the first time.
I did say all the above, in other words Phillip :arrowu: read though all the posts
2002 110 HDi estate, Rapier in monaco blue! ( found quite a bit more power :cheesy: )
1999 3.0 V6 SE coupe in Diablo Red ( my baby )
2006 206 1.4 16v sport in Aegean blue ( wife's shopping trolley :roll: )

pp2000 owner / user, can offer Diagnostic's / fault code, reading / clearing for beer tokens in Leicestershire.

caprixpack
2.0 16v
Posts: 150
Joined: Sun Mar 11, 2018 5:00 pm
Location: Cumbria

Re: going to have a go at welding the sills !

Post by caprixpack » Mon Jan 14, 2019 2:54 am

There does come a point where its just not worth it to keep throwing money at it. It was the same with my calibra, mechanically it was perfect but bodywise it was a nightmare. I changed both front wings the tailgate a door one of the sills drivers side floor pan, it was just one thing after another. Took it for its next mot and the tester called me over and stuck his finger through the passengers side floor in a few places, by this time one of the front wings had started going again. As much as I loved it, I had to let it go i just couldn't afford to keep replacing metal.
1984 924 2.0 n/a crystal Green - The daily
2005 VW Passat tdi 130 Highline, now 170bhp & 290ft/lb
2000 Peugeot 406 2.0 hdi - stood for 4 years, fresh mot and mostly working.

johntl
2.0 16v
Posts: 126
Joined: Fri Sep 24, 2010 7:38 pm
Location: cleveland , england

Re: going to have a go at welding the sills !

Post by johntl » Mon Jan 14, 2019 4:56 pm

Thanks for your input guys
If it goes through the MOT without to much trouble will keep for a few more years as long as the clutch 175k holds out, apart from the sills car is still in good nick
Hope it does not need to many patches on the sills ???

Post Reply