Paint not sticking to metal

Whether you're just washing the car, into detailing in a big way or enhancing your 406, collect and share hints and tips here.

Moderator: Moderators

Post Reply
FarmerPug
2.0 HDI 110
Posts: 9639
Joined: Tue Jun 01, 2010 5:42 pm
Location: The Countryside, Northern Ireland
Contact:

Paint not sticking to metal

Post by FarmerPug » Wed Jul 16, 2014 6:43 pm

A general question about painting metal, recently i ground the 305 driveshafts and anti roll bar back to bare metal getting rid of the flaky rust, they were nice and shiny, then sprayed on 3 coats of zinc 182 which claims to be anti rust primer, each coat was given a few hours to dry, then a day after the final coat, and finally painted with spray stone chip shield and also let dry, they have been dry for a few weeks now but i recently set one of the driveshafts down and scuffed it, but the paint went right back to the bare metal. What have i done wrong?

MixMan
1.8 16v
Posts: 83
Joined: Wed Aug 08, 2012 10:07 pm

Re: Paint not sticking to metal

Post by MixMan » Wed Jul 16, 2014 7:04 pm

At work I paint a lot of aluminium and to prepare for painting I use a two part etch primer. If I dont then the paint scratches off with your finger nail. Not sure if steel needs it as I never paint steel, but, just a suggestion.
Currently frustrated by: 2002 2.2HDi Executive Saloon

binnzy
2.0 16v
Posts: 130
Joined: Tue Mar 18, 2014 8:26 pm
Location: preston

Re: Paint not sticking to metal

Post by binnzy » Thu Jul 17, 2014 1:18 pm

did you degrease it first ie wash it off with thinners any grease or oil and the paint wont stick even getting hold of it with dirty hands will contaminate the metal and the paint wont stick
If it doesn't fit you need a bigger hammer

Post Reply