Handbrake centering? pins

Shocks, springs, anything to do with the running gear

Moderator: Moderators

Post Reply
runner1
1.8 8v
Posts: 38
Joined: Thu Apr 24, 2014 7:47 pm

Handbrake centering? pins

Post by runner1 » Thu Sep 22, 2016 8:43 pm

Hey folks so the pins holding my handbrake shoes worked loose and disappeared some time ago now due to an elongated hole in the back plate. I need to sort out. I have read here about the possibility of using a nut / bolt combo with washers to secure however I am concerned this will be far too rigid - I guess the original pin is designed to pivot a little on the back plate as it is not a pivot point on the actual shoes, have a got this right? Anyway tried this?
The only other way I can see is to weld a bit of plate or a washer in with a new suitably shaped hole..

Any ideas or experience appreciated!

dirtydirtydiesel
3.0 24v
Posts: 1279
Joined: Sun Apr 28, 2013 11:02 pm
Location: Coalville, Leics.

Re: Handbrake centering? pins

Post by dirtydirtydiesel » Thu Sep 22, 2016 9:26 pm

Hi,
I & others have been successfully using this setup for years,
I use M5 stainless countersunk caps,
From memory 45mm long with M5 st/st C type washers & M5 st/st nyloc nuts.
I machined two little st/st countersunk top hats to locate the springs but it's not essential (just I can).

The important thing is not to tighten the nut and bolt to much,
just enough to put the spring under tension to keep the brake shoes in place whilst allowing the shoes to move freely :)
2002 110 HDi estate, Rapier in monaco blue! ( found quite a bit more power :cheesy: )
1999 3.0 V6 SE coupe in Diablo Red ( my baby )
2006 206 1.4 16v sport in Aegean blue ( wife's shopping trolley :roll: )

pp2000 owner / user, can offer Diagnostic's / fault code, reading / clearing for beer tokens in Leicestershire.

User avatar
GingerMagic
3.0 24v
Posts: 3066
Joined: Fri Apr 06, 2012 9:02 pm
Location: Bournemouth

Re: Handbrake centering? pins

Post by GingerMagic » Thu Sep 22, 2016 10:08 pm

Do you still have the short stubby springs that keep the shoes pushed against the backplate?
Replacements are available in a kit for about £6 - unless you can think of an alternative spring.....
1999 T4 family wagon
2005 Vauxhall Meriva
1998 406 V6 Coupe - Midlife crisis..!
PP2000 user, can help with faults / diagnostics in the Bournemouth area.

Post Reply