someone with a d9 must know???????????

Discuss the 406's Bodywork stuff in here (what parts fit what, what can be interchanged with what etc etc).

Moderator: Moderators

Post Reply
trem1
3.0 24v
Posts: 1779
Joined: Sat Dec 31, 2005 3:32 pm
Location: south shields,tyneside

someone with a d9 must know???????????

Post by trem1 » Thu Aug 24, 2006 8:00 pm

someone with a d9 must know the panel with the radio / temp/info has two smaller panels on either side of it. the question is are they separate as in three panels or all one, i ask because i want to mount my sat-nav on the small left hand side one but would like to know how it comes to bits and if its all one piece, someone has definatly taken theres to bits so help me out guys :cheesy:

Saturnine
1.8 8v
Posts: 20
Joined: Sun Oct 16, 2005 2:23 am
Location: Denmark
Contact:

Post by Saturnine » Thu Aug 24, 2006 9:23 pm

You can click them out, under each one there are 2 torx screws.. :)
:)

chili
2.0 16v
Posts: 186
Joined: Sat Aug 05, 2006 8:12 pm

Post by chili » Thu Aug 24, 2006 9:58 pm

just replaced mine last week. basically they are blanking plates either side of the radio and behind them are as stated torx screws keeping radio in place. get a small screw driver and just pop it out. the hole is not very deep though probably 30mm at most

trem1
3.0 24v
Posts: 1779
Joined: Sat Dec 31, 2005 3:32 pm
Location: south shields,tyneside

Post by trem1 » Fri Aug 25, 2006 9:29 am

so could i take left hand side one off and keep it safe(as in lose it) to mount my sat-nav there , for it to be easily replaced at a later date with no-one any the wiser????? :!:

trem1
3.0 24v
Posts: 1779
Joined: Sat Dec 31, 2005 3:32 pm
Location: south shields,tyneside

Post by trem1 » Fri Aug 25, 2006 3:45 pm

anybody know how much they cost???

Post Reply