Search found 15 matches

by paniya88
Fri Nov 17, 2017 4:15 am
Forum: Engine, Clutch and Transmission
Topic: Engine bay is too hot
Replies: 0
Views: 598

Engine bay is too hot

My 2.0 16v 406 had faulty stepper motor and TPS. I replaced the stepper with new Magneti Marelli one but didn't change the TPS. I notice that after about 30 minutes of driving engine bay is too hot. If I keep my hands on TPS and stepper for few minutes my fingers will be burnt. I want to know if the...
by paniya88
Sat Jul 08, 2017 10:01 am
Forum: Engine, Clutch and Transmission
Topic: Rough idle & slight jerk when pressing & releasing accelerat
Replies: 0
Views: 700

Rough idle & slight jerk when pressing & releasing accelerat

I replaced the stepper motor and TPS yet the problem persisted. Is it could be a vaccum leak? Also car need to crank for for few seconds to start. Car is petrol one
by paniya88
Thu Jul 06, 2017 6:28 am
Forum: I.C.E and In-Car Technology
Topic: Lcd screen replacement
Replies: 12
Views: 4197

Re: Lcd screen replacement

My car lcd display part no is 9641902577 A00 and found a replacement part with same no but R00 instead of A00. Will it be compatible with my car?
by paniya88
Thu Jun 29, 2017 3:54 am
Forum: Interior
Topic: How to clean ac drain line?
Replies: 2
Views: 957

Re: How to clean ac drain line?

Hi, no need to remove the dashboard. Undo the little torx screw which is located near the rear end of the centre console. drivers side. Remove the ashtray ( just lifts up, maybe do the gaiter first ) Undo the torx on the inside of the console, drivers side near the gearstick. Remove drivers side co...
by paniya88
Wed Jun 28, 2017 4:54 pm
Forum: Interior
Topic: How to clean ac drain line?
Replies: 2
Views: 957

How to clean ac drain line?

My car is leaking water in to both front footwells and it should be from the ac drain lines because this happens even on sunny days. Do I have to remove the dashboard to clean it? Thanks in advance
by paniya88
Wed Jun 07, 2017 4:07 pm
Forum: Electrical System and Diagnostics
Topic: Center lock won't work after few seconds
Replies: 9
Views: 2776

Re: Center lock won't work after few seconds

Thanks for everyone. Finally issue has been solved. It was broken wire like you told. My mechanic checked wire harness and found the broken wire. Thanks again everyone specially frog
by paniya88
Mon May 22, 2017 11:02 am
Forum: Engine, Clutch and Transmission
Topic: Running manual car with automatic ecu
Replies: 1
Views: 736

Running manual car with automatic ecu

My car has manual transmission and it run on automatic ecu. In idle rpm fluctuates between 800-1000 and while driving I can feel slight jerk when pressing or releasing the accelerator. Also sometimes car suddenly stalls when try to move after stopping for traffic. Is this caused by the auto ecu or s...
by paniya88
Fri Apr 28, 2017 9:56 am
Forum: Electrical System and Diagnostics
Topic: Center lock won't work after few seconds
Replies: 9
Views: 2776

Re: Center lock won't work after few seconds

I summarize your issues. After contact off and removal of key, after 30 seconds: - Radio loses all its memorised channels - Door puddle lights turn off - Central door locking does not work, key operates only mechanically opening one door at a time I looked in SEDRE (the DVD with the electrical sche...
by paniya88
Thu Apr 27, 2017 4:45 am
Forum: Electrical System and Diagnostics
Topic: Mirror Controls
Replies: 4
Views: 1072

Re: Mirror Controls

I also have a problem with side mirrors and seats. When I turn on the key sometimes seat move forward and mirrors are readjusting. My mechanic told it's due to the memory seats unit. You might want to check that
by paniya88
Wed Apr 26, 2017 2:59 pm
Forum: Electrical System and Diagnostics
Topic: Center lock won't work after few seconds
Replies: 9
Views: 2776

Re: Center lock won't work after few seconds

Maybe a blown fuse, from Haynes it looks like MF8 (maxi-fuse 8, "Passenger compartment fuse") or MF9 ("Built-in system interface") are good candidates to check. Maxi fuses are in the engine compartment fuse box (BM34). In some models, the maxi fuses cannot be accessed directly, they in a separate b...
by paniya88
Fri Apr 21, 2017 12:02 pm
Forum: Electrical System and Diagnostics
Topic: Center lock won't work after few seconds
Replies: 9
Views: 2776

Re: Center lock won't work after few seconds

Maybe a blown fuse, from Haynes it looks like MF8 (maxi-fuse 8, "Passenger compartment fuse") or MF9 ("Built-in system interface") are good candidates to check. Maxi fuses are in the engine compartment fuse box (BM34). In some models, the maxi fuses cannot be accessed directly, they in a separate b...
by paniya88
Thu Apr 20, 2017 5:55 am
Forum: Electrical System and Diagnostics
Topic: Center lock won't work after few seconds
Replies: 9
Views: 2776

Center lock won't work after few seconds

Center lock won't work few seconds after I took the key from ignition barrel
It seems like power to the doors will be cut down after few seconds. Door puddle light also turn off and Display time & radio channels reset when I turn on the key.
What might be causing this? Car is 2001 peugeot 406 2.0 16v
by paniya88
Tue Mar 21, 2017 12:15 pm
Forum: Electrical System and Diagnostics
Topic: 406 meter panel light when ignition is off
Replies: 2
Views: 920

Re: 406 meter panel light when ignition is off

Hello and welcome. I would look for water under the carpet on the right side front of the car - it may be dry on top but really wet underneath. I would then do a BSI reset, which may help. To do this you need to; Unlock the car and open the bonnet. Put the drivers window down and then lock the car ...
by paniya88
Tue Mar 21, 2017 4:42 am
Forum: Electrical System and Diagnostics
Topic: 406 meter panel light when ignition is off
Replies: 2
Views: 920

406 meter panel light when ignition is off

Hi! I just got a 406 2.0 gasoline sedan. About 1min after I turn off the ignition meter panel & ac panel light up. When I open or close the door panels are off and comes back on after about 1min. After 1 day my battery is also dead. What's your expert opinion on this. Thanks in advance